+================================================
+                                                
+ G Code - Vectric machine output configuration file   
+                                                
+================================================
+                                                
+ History                                        
+                                                
+ Who      When       What                         
+ ======== ========== ===========================
+ Tony     11/12/2007 Written                      
+================================================

POST_NAME = "CNCShark - USB (inch) (*.tap)"

FILE_EXTENSION = "tap"

UNITS = "INCHES"

+------------------------------------------------
+    Line terminating characters                 
+------------------------------------------------

LINE_ENDING = "[13][10]"

+------------------------------------------------
+    Block numbering                             
+------------------------------------------------

LINE_NUMBER_START     = 0
LINE_NUMBER_INCREMENT = 10
LINE_NUMBER_MAXIMUM = 999999

+================================================
+                                                
+    Formating for variables                     
+                                                
+================================================

VAR LINE_NUMBER = [N|A|N|1.0]
VAR SPINDLE_SPEED = [S|A|S|1.0]
VAR FEED_RATE = [F|A|F|1.1]
VAR X_POSITION = [X|A| X|1.4]
VAR Y_POSITION = [Y|A| Y|1.4]
VAR Z_POSITION = [Z|A| Z|1.4]
VAR ARC_CENTRE_I_INC_POSITION = [I|A| I|1.4]
VAR ARC_CENTRE_J_INC_POSITION = [J|A| J|1.4]
VAR X_HOME_POSITION = [XH|A| X|1.4]
VAR Y_HOME_POSITION = [YH|A| Y|1.4]
VAR Z_HOME_POSITION = [ZH|A| Z|1.4]

+================================================
+                                                
+    Block definitions for toolpath output       
+                                                
+================================================

+---------------------------------------------------
+  Commands output at the start of the file
+---------------------------------------------------

begin HEADER


"G90"
"G20"
"[F]"


+---------------------------------------------------
+  Commands output for rapid moves 
+---------------------------------------------------

begin RAPID_MOVE

"G00[X][Y][Z]"


+---------------------------------------------------
+  Commands output for the first feed rate move
+---------------------------------------------------

begin FIRST_FEED_MOVE

"G01[X][Y][Z]"
"[F]"


+---------------------------------------------------
+  Commands output for feed rate moves
+---------------------------------------------------

begin FEED_MOVE

"G01[X][Y][Z]"

+---------------------------------------------------
+  Commands output for the first clockwise arc move
+---------------------------------------------------

begin FIRST_CW_ARC_MOVE

"G02[X][Y][I][J]"
"[F]"


+---------------------------------------------------
+  Commands output for clockwise arc  move
+---------------------------------------------------

begin CW_ARC_MOVE

"G02[X][Y][I][J]"


+---------------------------------------------------
+  Commands output for the first counterclockwise arc move
+---------------------------------------------------

begin FIRST_CCW_ARC_MOVE

"G03[X][Y][I][J]"
"[F]"


+---------------------------------------------------
+  Commands output for counterclockwise arc  move
+---------------------------------------------------

begin CCW_ARC_MOVE

"G03[X][Y][I][J]"


+---------------------------------------------------
+  Commands output at the end of the file
+---------------------------------------------------

begin FOOTER

"M02"